HDAT2 (ALL-IN-ONE BOOT Version) – is program for test or diagnostics of ATA/ATAPI/SATA, SSD and SCSI/USB devices.It will not execute in a DOS session under Windows.
You should make a DOS boot floppy disk or CD/DVD and boot your system for it and execute this program from that floppy disk or CD-ROM.
HDAT2 program has 2 levels:
Device testing
– main function is testing and repair (to regenerate) bad sectors for detected devices
– you get much information about detected devices
File system testing
– read/find/check items (MBR, boot, directories, etc.) of file system FAT12/16/32
– check/remove (regenerates) bad sectors records, flags in FAT table
Features
• fully implemented commands: SET MAX, SET SECURITY, Device Configuration Overlay (DCO)
• device access with interrupt 13h, direct via ATA ports, with ASPI drivers
• detects ATA/ATAPI/SATA devices with on-board and add-on controllers
• detects devices on AHCI/RAID controllers (just only on ports 0-3)
• detects USB devices via USB ASPI driver or BIOS (if supported)
• detects SCSI hard drives via BIOS interrupt 13h or ASPI drivers
• other SCSI devices are detected via ASPI drivers only (must be loaded before);
• with ASPI drivers you will get more information about SCSI devices
• test and repair device for bad sectors (so far version 4.5.3 only)
• many different test-functions for hard drives
• resize hard drives which supports SET MAX ADDRESS/EXT
• (supports 28/48-bits LBA addressing modes)
• drive lock detection via security feature (Security Menu)
• S.M.A.R.T. functions for ATA/SATA and SCSI drives only
• information about devices (ATA/ATAPI, BIOS interrupt 13h, ASPI, EDD)
• sector viewer for devices (also for USB, ZIP, CD-data discs)
• to access ATA/SATA CD/DVD drive you don’t need any driver or MSCDEX
• enable/disable some features for direct-access devices
• Device Configuration Overlay (DCO) feature set
• (you can restore a full capacity or allow/disallow some feature sets of hard drive)
Known limitations:
• change SATA controller in BIOS from AHCI to IDE/ATA/legacy mode
• devices SATA/AHCI/RAID detect on ports 0-3 only
Download
HDAT2.v7.5.rar – 6.9 MB
This post was recently updated on January 16, 2023